Hi guys,
I got my AQ6 in with the mail, and soldered all the pins on to the board. After that i put a microSD card in the AQ and hooked the AQ up to a 7.2v battery. The power led went solid red, without the J4 jumper being connected( i also checked that the solder wasn't connected). So i tried tried to connect the AQ with my computer with the flyduino cp2012. I connected it as it was on the wiki.
to what i thought to be firmware mode. After installing the drivers i opened the qgroundcontrol, i tried to update the firmware. But i wouln't not do anything. This is my setup
When i try to just connect the AQ as in the wiki, it said: Link serial port /dev/tty.SLAB_USBtoUART is connected.
But i get no data at al. I already read that the connection is to the usb device it self, and i checked when the cp2012 is disconnected from the AQ it still "connects".
So is my AQ dead? Or is there something i can try more?
Raymond Astudillo