Wrong Voltage shown in QGCS

[aqchab]

Hi,

i don´t know if this is a hardware or a software issue

i setup the AQ with 3S Lipo - but in QGCS display says 20.1V ether Win or Mac so i think this is hardware

[JussiH]

Have you loaded the correct version FW?

If your board was after october 2012, it will be an R2 board.

[aqchab]

the file name aqv6.6.r76.-rev2.hex

[JussiH]

When did you buy the board?

[aqchab]

6.12.2012 from viacopter

[JussiH]

Ok,

Then it could point to a problem with the hardware. I will have to ask you send it back here for examination - if its dodgy, I will repair it or replace it with a new board. info(at)viacopter.eu

[aqchab]

ok thank you for your quick answer i´ll write to info(at)viacopter.eu

[Kisssys]

Maybe I'm reading this wrong but it looks like he has a Rev1 board and a Rev2 hex which would give that reading.

[JussiH]

If ordered after october 2012 it should be a rev2 board.

[Kisssys]

Oh read the date the US way, I read the date as June 12, 2012