AQ not regestering throttle channel

[graham_newton]

Hi

I cannot see any movement on the throttle channel when using dx8.
All the other channels work.

I have rebound it but the issue persists...
Any ideas?

Thank

[graham_newton]

Tried a different sat rx. still nothing!
Very frustrating, It worked on a cheap orange sat rx.

But not on a dsmx one. It does not pick up thr and aux3.
Is there a window where I can assign channels?

Anyone got some advice?

Thanks

[JussiH]

Have you set to 11-bit?

You may also want to look at the channel order. When the SX (DSX7) protocols was introduced, spektrum changed the channel order in the serial stream.

[chschmid]

When I remember right, you need to bind it in DSM2 mode, DSMX is not supported yet.
When bound to a receiver <8000, use 10bit, otherwise 11bit.

Best

Christof

[graham_newton]

OK thanks ill give it a try. Had to put my HFP board in because of time constraints.
But very excited to see how the AQ handles a heavy lift X8.