[phpBB Debug] PHP Warning: in file [ROOT]/includes/bbcode.php on line 384: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
AutoQuad Forum • View topic - ESC32 V3 can't be used on PWM
Page 1 of 1

ESC32 V3 can't be used on PWM

PostPosted: Sat Jun 17, 2017 5:47 am
by oscar0613
Hi everyone:

I bought a ESC32 V3, and I've installed it well.
Finally, I can calibrate it on computer, but can't use it on PWM receiver.
My equipment is Futaba R7008SB, and it can work well on servo motor, but when I change it on the ESC32 V3. it is died, can't work.
I've checked the filed in this form, and I know I need to correct the parameter of PWM_MIN_PERIOD = 2200 us
PWM_MAX_PERIOD = 25000 us
Unfortunately, it still can't work.
Can anyone tell me what's going on? Is that the problem of the line connection? or about setting? and how to correct it?
Image

My software setting and setting version is shown at below.
> version
ESC32 ver 3.3.3

> set LIST
STARTUP_MODE = 0
BAUD_RATE = 230400 baud
PTERM = 0.500
ITERM = 0.00500
FF1TERM = -9.77835e-11
FF2TERM = +1.44798e-03
MIN_PERIOD = 50 us
MAX_PERIOD = 12000 us
ADVANCE = 15.00 Degs
START_VOLTAGE = 0.75 Volts
GOOD_DETECTS_START = 48
BAD_DETECTS_DISARM = 32
MAX_CURRENT = 1.00 Amps
START_CURRENT = 0.75 Amps
SWITCH_FREQ = 20.0 KHz
MOTOR_POLES = 14
PWM_MIN_PERIOD = 2200 us
PWM_MAX_PERIOD = 25000 us
PWM_MIN_VALUE = 750 us
PWM_LO_VALUE = 1000 us
PWM_HI_VALUE = 1950 us
PWM_MAX_VALUE = 2250 us
PWM_MIN_START = 1100 us
PWM_RPM_SCALE = 7900 RPM
ACTIVE_FREEWHEEL = 1
THR1TERM = +0.00000e+00
THR2TERM = +1.00000e+00
RPM_MEAS_LP = 0.750
SERVO_DUTY = 5.0 %
SERVO_P = 0.050
SERVO_D = 0.000
SERVO_MAX_RATE = 1000.0 deg/s
SERVO_SCALE = 360.0 deg
ESC_ID = 1
DIRECTION = 1
AUDIO_VOLUME = 0.0

Please see the following video of what I've done.

Looking forward to hearing from you.
Thank you very much.
Sincerely,
Oscar

https://youtu.be/N80qGol1F_c

Re: ESC32 V3 can't be used on PWM

PostPosted: Mon Jun 19, 2017 10:37 pm
by sandmen
Did you try to disconnect the USB Connection ? It should be only one interface ( pwm or USB) possible.