esc32v3 compatibility with Pixhawk CAN
Posted: Wed Oct 12, 2016 6:37 am
Hey all,
I was wondering if anyone has integrated the esc32v3's with a Pixhawk FCU via CAN (both use 5V).
Is it as simple as giving the esc32v3s an ID in the config utility, and referencing the IDs on the Pixhawk (via QGC)?
If not, what more must be done to make them compatible?
Thanks,
I was wondering if anyone has integrated the esc32v3's with a Pixhawk FCU via CAN (both use 5V).
Is it as simple as giving the esc32v3s an ID in the config utility, and referencing the IDs on the Pixhawk (via QGC)?
If not, what more must be done to make them compatible?
Thanks,