Page 1 of 1

How to check MOT_CAN

PostPosted: Wed Jul 08, 2015 4:47 am
by jet
Hi, all.
Today, I calibrated my ESC32 and CAN Bus.
Through CAN bus, all ESC32 could get the identical calibration values.
However, I cannot find the screen regarding MOT_CAN in QGC1.6.3 as well as AQ wiki.
How to check this screen?
Also, why does the MOT_CANH and MOT_CANL were 0 in my QGC? what 's the problem?
Thanks for help.
Jet

Re: How to check MOT_CAN

PostPosted: Wed Jul 08, 2015 12:52 pm
by LPR
You need to go to the motor mix in the QGC and change the PWM setting to CAN.

That will change the setting you see in the parameters for CAN.

You can see the Telemetry from the ESC32 when to use this Widget.

To use the Widget you need to click on the arrow in telemetry screen.

Larry

Re: How to check MOT_CAN

PostPosted: Wed Jul 08, 2015 1:53 pm
by jet
Hi, Larry.
Cool~I got it.
I will try your method.
Thanks for your help.
Jet