help PWM input don't work

Info and Discussion about the ESC32 hardware and software

help PWM input don't work

Postby fahdovski » Mon Jul 06, 2015 12:48 pm

Hi all,
I'm able to connect to the Qground and change RPM with the interface using an FTDI.
But i get the red blinking led when i'm in PWM mode. I'm sending standard 1-2ms 100hz Pwm signal. I checked it with an oscilloscope. I'm powering the ESC via 5v of the FTDI connected to PC.
Please need your help i do not understand the problem here.
Thx
Attachments
screenshot QgroundControl ESC32 Firmware 2.1.0.6185     Hardware v2.1.png
fahdovski
 
Posts: 9
Joined: Thu May 21, 2015 2:22 pm

Re: help PWM input don't work

Postby chschmid » Mon Jul 06, 2015 1:02 pm

Do you have a servotester?

Hook it to the ESC32 PWM connectors, power up and you can run the motor.
Otherwise let me know what exacly you want do with what connections.

Cheers
Christof
chschmid
 
Posts: 1800
Joined: Wed Jul 11, 2012 7:41 pm
Location: Herrliberg, Switzerland

Re: help PWM input don't work

Postby fahdovski » Mon Jul 06, 2015 1:28 pm

Solved by setting min throttle at 1050us for a 1000us pwm signal measured with oscilloscope
fahdovski
 
Posts: 9
Joined: Thu May 21, 2015 2:22 pm


Return to ESC32

Who is online

Users browsing this forum: No registered users and 16 guests

cron