Hello Everyone,
I am building a quadrotor with Pixhawk and ESC32. Until I did try to ESC calibration everything was working properly. After I followed the calibration steps on http://copter.ardupilot.com/wiki/initia ... esc-motor/ , I got this problem with ESCs. I can arm them properly but whenever I try motor test or calibration with qgc they suddenly disarm just after motors start spinning. Any help is appreciated. Thanks in advance.
Tarik
Disarmed Esc32 just after motors start spinning
6 posts
• Page 1 of 1
Disarmed Esc32 just after motors start spinning
by trkygt » Mon Jun 22, 2015 8:55 pm
- trkygt
- Posts: 2
- Joined: Mon Jun 22, 2015 8:36 pm
Re: Disarmed Esc32 just after motors start spinning
by LPR » Tue Jun 23, 2015 12:06 am
Tarik
The first thing you need to do is save the settings file and post it here.
Larry
The first thing you need to do is save the settings file and post it here.
Larry
- LPR
- Posts: 1323
- Joined: Tue Jun 26, 2012 1:29 pm
- Location: MN, USA
Re: Disarmed Esc32 just after motors start spinning
by aBUGSworstnightmare » Tue Jun 23, 2015 5:37 am
- aBUGSworstnightmare
- Posts: 1460
- Joined: Fri Jun 22, 2012 5:24 pm
Re: Disarmed Esc32 just after motors start spinning
by trkygt » Thu Jul 02, 2015 4:10 pm
- trkygt
- Posts: 2
- Joined: Mon Jun 22, 2015 8:36 pm
Re: Disarmed Esc32 just after motors start spinning
by aBUGSworstnightmare » Fri Jul 03, 2015 6:26 am
- aBUGSworstnightmare
- Posts: 1460
- Joined: Fri Jun 22, 2012 5:24 pm
Re: Disarmed Esc32 just after motors start spinning
by chschmid » Fri Jul 03, 2015 8:33 pm
Your bat voltage is a bit low. What batt are you using?
You could start telemetry to observe your bat voltage.
Cheers
Christof
You could start telemetry to observe your bat voltage.
Cheers
Christof
- chschmid
- Posts: 1800
- Joined: Wed Jul 11, 2012 7:41 pm
- Location: Herrliberg, Switzerland
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests