Page 2 of 2
Re: PWM doesn't work anymore
Posted:
Mon Jun 22, 2015 6:11 pmby chschmid
Hi David
Do you have RX - TX, TX - RX connected? If you have your FDTI cable with the black wire on the GND side, you need a straight connection to the ESC32.
I usually short BOOT Pins and keep them shorted, connect FDTI, then the mains (batt), then flash.
Cheers
Christof
Re: PWM doesn't work anymore
Posted:
Mon Jun 22, 2015 6:19 pmby David Salvador
I have TX and RX well connected. The communication is working fine, i can run the motor via ftdi with no problem. The only thing i can't do is flash the esc32 again and run the esc32 via pwm.
Re: PWM doesn't work anymore
Posted:
Mon Jun 22, 2015 9:15 pmby chschmid
Did you try that, in this order? And no other serial connection open! Just start QGC new, short BOOT Pins and keep them shorted, connect FDTI, then the mains (batt), then flash.
Re: PWM doesn't work anymore
Posted:
Mon Jun 22, 2015 10:06 pmby David Salvador
Yes, i tried in that order. And the error remains the same.
Re: PWM doesn't work anymore
Posted:
Mon Jun 22, 2015 10:18 pmby Max
If ESC power jumper is set to V5 position, then you definitely don't need battery hooked up. In fact I'd avoid it, especially if there's a motor connected as well. 5v from the FTDI adapter, with no other power hooked up, is my personal preference.
-Max
Re: PWM doesn't work anymore
Posted:
Tue Jun 23, 2015 5:33 amby aBUGSworstnightmare
Re: PWM doesn't work anymore
Posted:
Tue Jun 23, 2015 12:28 pmby David Salvador
I know that. First i short the BOOT0, then i connect the FTDI. The ESC power jumper is set to 5v position, so i don't connect the battery. And the motores are also not connected.
I even try to sold the boot jumper, to make sure they are well connected.