Hi all,
I cannot establish communication between my ESC32 and the qgroundControl.
I put
TX Ftdi to RX of ESC32
RX Ftdi to TX Esc32
5v and GND. I have a 3.3v FTDI version.
I was able to run the ESC32 with default firmware with a PWM servo signal.
But when i try to use qgroundcontrol for more in depth control of the ESC32, it connects but i do not have any feedback on parameters. I also cannot update the firmware even if i Put the boot jumper before. I always says that ESC32 is not in bootloader mode trying to force it... but I did connect the jumber.
I'm powering it with the UART for the signal.
Please need your help.
Thanks