Page 1 of 1
Calibration in closed loop rpm with quatos ?
Posted:
Sun Mar 01, 2015 6:44 pm
by plexus
Hi,
In the wiki it is written to calibrate the ESC32 in closed loop rpm if quatos is used.
can i keep that config if I dont use quatos ?
Because i dont understand " open loop/close loop"
Alain
Re: Calibration in closed loop rpm with quatos ?
Posted:
Sun Mar 01, 2015 9:12 pm
by LPR
Alain
Using open loop your PWM input value gives you a power setting and your motor RPM will change with air density and size of prop.
Using Closed loop your PWM value gives you a RPM setting and will not change with a load change.
Larry
Re: Calibration in closed loop rpm with quatos ?
Posted:
Mon Mar 02, 2015 2:57 pm
by plexus
Many thanks Larry for your reply.
Alain
Re: Calibration in closed loop rpm with quatos ?
Posted:
Tue Apr 14, 2015 7:08 am
by afernan
@Alain:
You can´t use CL if not using QUATOS (in general). But it´s worth to try. Probably you´ll get some vibration couplings (high ACC levels)
Angel
Re: Calibration in closed loop rpm with quatos ?
Posted:
Tue Apr 14, 2015 4:52 pm
by aBUGSworstnightmare