Calibration in closed loop rpm with quatos ?

[plexus]

Hi,
In the wiki it is written to calibrate the ESC32 in closed loop rpm if quatos is used.
can i keep that config if I dont use quatos ?
Because i dont understand " open loop/close loop"

Alain

[LPR]

Alain

Using open loop your PWM input value gives you a power setting and your motor RPM will change with air density and size of prop.

Using Closed loop your PWM value gives you a RPM setting and will not change with a load change.

Larry

[plexus]

Many thanks Larry for your reply.
Alain

[afernan]

@Alain:
You can´t use CL if not using QUATOS (in general). But it´s worth to try. Probably you´ll get some vibration couplings (high ACC levels)

Angel

[aBUGSworstnightmare]