Hi guys,
I was trying to control my motors with closed loop RPM, so I performed calibration (both rpm and current) for all the four ESCs.
Then I set the pwm parameters to:
PWM_MIN_VALUE 750
PWM_LO_VALUE 1000
PWM_HI_VALUE 2100
PWM_MAX_VALUE 2250
PWM_MIN_START 1100
PWM_RPM_SCALE 8500 (maximum rmp for my motor)
I then put control mode "RPM" and input mode "PWM".
By sending a sequence of PWM as: 900-->1000-->1100 (with some time between them) the ESCs does not arm nor start....nothing, while before doing calibration they were arming at 900 and starting at 1100 PWM. What could be wrong?
PS: I noticed MAX_CURRENT now is set to 0. Is this normal? Which value should I use?