Can't flash firmware

Info and Discussion about the ESC32 hardware and software

Re: Can't flash firmware

Postby erom » Mon Oct 13, 2014 11:27 am

Hey guys, I finally made it work.
Obviously it was something really stupid: I needed to connect Rx WITH Rx and Tx WITH Tx.
I should have tried before, but it didn't make sense to me, because like Norbert said: Transmit should be connected to Receive. And all i found on the forum was confirming that. I didnt' know that sometimes it works the other way around.
By the way, thank you a lot for the support! You were very helpful!

Regards,
Edoardo
erom
 
Posts: 7
Joined: Wed Oct 08, 2014 11:16 am

Previous

Return to ESC32

Who is online

Users browsing this forum: No registered users and 9 guests

cron