ESC32v3.....

[Jdmagoo]

Just wondering how far this is away from been released? I'm planning to build a new platform and have 6S in mind and would like to use the new esc's.

And whilst I'm asking, the M4 must be due soon?

Thanks

James

[JussiH]

Hello James

There is no definate ETA on the v3 at this moment. But it is in motion.

We are gearing up to release a limited number of M4´s and the Quatos adaptive controller very soon. It turned out to be a bigger job than expected to get all the documentation and tools up to date and the team has been working very hard on it for some time now.

[Jdmagoo]

Thanks Jussi, really hope all this is released soon. Can't wait for the expansion board and v3 of the esc32. I may have to get an M4 as well-

Keep up the good work

[TheBone]

I just want to ask: What's new?

[kinderkram]

[TheBone]

Thank you for your replay.
I hope you'll release it soon, cause I think it would be the better way for my project. I give it up with the ESC32v2. But I have to finish in a few months. And at the moment the copter not even fly one time.
Sorry for the OT.

[Astudillo]

[kinderkram]

Hi Raymond,

yes - the telemetry goes via CAN bus through the FC but changing parameters etc. reqires a serial connection, e.g. via USB.

The layout of the PCB is pretty "final" though you can´t really say that for prototypes in general.
But testing is making good progress and so far no hardware related flaws *fingers crossed*.

Atm we have to deal with problems we didn´t cause: STM isn´t able or willing to provide a certified native USB driver for their chips.

But since we worked around the same flaw on the M4 I´m confident we´ll have it ready for the launch...

Norbert

[leopold1]

Now that the ESC32 V2 isen't available anymore, will there be a new batch or is the ESC32 V3 just arround the corner?

[JussiH]

ESC32v3 should become available before end of April