Calibration with qgroundcontrol (RPM/CLimiter) depends on..
Posted: Tue Sep 23, 2014 9:21 pm
Hi all!
When calibrating the ESC32 for Current Limiter and RPM2Voltage, i found a small issue.
With "minthrottle" and "motor start" at default values, everything works fine after tuning the settings. But when i rise "minthrottle" to 1100 and "motor start" to 1150 (for my Graupner Radio), it doesn't work. (Motor does not start)
I thought qgroundcontrol would send values to the ESC32 regardless of the PWM settings,...
Used qgroundcontrol 1.5 for Windows.
Any ideas?
Best regards,
Yannick
When calibrating the ESC32 for Current Limiter and RPM2Voltage, i found a small issue.
With "minthrottle" and "motor start" at default values, everything works fine after tuning the settings. But when i rise "minthrottle" to 1100 and "motor start" to 1150 (for my Graupner Radio), it doesn't work. (Motor does not start)
I thought qgroundcontrol would send values to the ESC32 regardless of the PWM settings,...
Used qgroundcontrol 1.5 for Windows.
Any ideas?
Best regards,
Yannick