Hi guys,
I am a freshman, and I met some problems about my esc. Hope you guys could give me some suggestions.
After flashing the firmware to esc successfully, I can connect my esc to QGroundControl and arm it. When I click "start", the motor can run, but for only 2.5 seconds, then the esc disarms itself (red led blinking). Also, when I click "start calibration", the same circumstance happens again. Anyone knows what is wrong?
BTW, if I want to do calibration, do I need to alter those parameters myself (current limiter, FF1 term, etc.) or just click "start calibration". My motor is TMotor MN4014-11 KV330.
Any suggestion is appreciated.