Page 5 of 5

Re: Problem with ESC32 or FutabaT8J config ? First flight fa

PostPosted: Mon Jul 07, 2014 3:47 pm
by Dju
There is no idea ? As I said, I follow each step, I don't know what happens, and I don't want to do the them thing again for the next time... :( :( :(

Re: Problem with ESC32 or FutabaT8J config ? First flight fa

PostPosted: Mon Jul 07, 2014 8:19 pm
by LPR
Dju

The only way I've been able to make a ESC32 fail is to get them wet.

There is a slight chance that powering the AQ board with 5 volts may have been the cause your problem.

The voltage regulators on the AQ board need to be powered with a min 6.5 volts.

Larry

Re: Problem with ESC32 or FutabaT8J config ? First flight fa

PostPosted: Tue Jul 08, 2014 3:52 pm
by Dju
OK thanks Larry for helping me.
Now I power the AQ board with a min of 6,5V, and I'm waiting other ESC simonK for the first fly :)

Actually, I really don't see the relation between powering 5V AQ board and ESC32, because I just connected the sng wire between aq board and ESC32, so they wasn't powered by the aq board, but by 5vinput and the main power.

I will tell you if I find the answer.
Best regards

Julien

Re: Problem with ESC32 or FutabaT8J config ? First flight fa

PostPosted: Wed Jul 09, 2014 2:22 am
by LPR
Dju

You must have a ground and signal wire from the AQ board connected to the ESC32.

Larry

Re: Problem with ESC32 or FutabaT8J config ? First flight fa

PostPosted: Wed Jul 09, 2014 11:35 am
by Dju
ok Larry, thank you,
I follow a wrong post. I should have follow my knowledge.
I will tell you what's going on when I receive the other ESC.

Best regards

Dju