Page 2 of 5
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 10:22 am
by Dju
I bought the dji F450 kit, and the motors are 4 moteurs DJI 920Kv E300.
I'm begining the tests right now
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 10:33 am
by aBUGSworstnightmare
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 10:47 am
by Dju
So I can't use the esc32 with this motor ?
Can I use opto esc with autoquad ?
I flash the esc with the esc32 v2.1.0.r56 and it's the same, I can arm the esc, i see the led green light up, but i don't get the motor..
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 11:00 am
by bluuu
once again, do you arm by GCS ? (by using arm and start button) ?
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 11:40 am
by Dju
Yes exactly, when i press arm, the green led light up but when i press start button nothing happens
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 11:40 am
by Dju
i arm by GCS
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 11:43 am
by bluuu
looks like no power on motor side
Are you sure the lipo is connected ?
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 11:47 am
by Dju
yes, I power the esc to a ubec 3A and the ubec to the lipo, when I connect everything, the red led blinks on the esc, and i connect the motor to the esc with the 3 connectors
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 11:50 am
by bluuu
hmm, and where is a connection esc to main battery ?
+5V powering logical side of esc
You must connect a main power too.
http://autoquad.org/wiki/wiki/esc32/esc ... are-setup/
Re: Problem with ESC32 or FutabaT8J config ? First flight fa
Posted:
Wed Jun 25, 2014 11:55 am
by Dju
can i connect the pwm connection with gnd + and signal the the autoquad and the main power to the lipo ?
Or can i connect the gnd and + to the lipo and the main power too ?
I'm not wrong if I connect the main power at the same place than the capacitor ?