Hi everyone,
I'm trying to do my first flight since two day without any succes.
I really need help, I'm losing my mind, it's really disappointed, I'm going to be crazy
I flash the esc32 and I can see all the paramaters in the QGC, but with my 4 ESC32, I can't start the motor with the QGC.
I connect the esc with the ftdi( also the rx tx and gnd cable) I power the escs with my lipo, and I'm in V5 mode.
Everything seems good but nothing happens with the motors. I can see the led red blinking when i power and the green light up when i click on arm.... so I think everything should be fine..
When I power my model, every esc32 have the green led light up except one which has the red led blinkig=ng, so she doesn't be armed andd I don't know why....
My led receiver (futaba r2008sb) is red when I power the model and swith to green when I power my futaba T8J.
But nothing happens when i move the sticks...
My AQ board is red when i power the model and the led ready is blinking when i power the futaba T8J... and the gps led is blinking blue too....
I really don't understand what happens... I follow all the wiki and the differents discussion on thsi forum but I can't make my first flight