Hi,
So I took somes pictures of my model.
I soldered the ftdi header, the boot jumper too. I connected the capacitor and the main power. I put the esc32 in the V5 mode.
I really think that I don't make any mistake soldering the esc32.
After that I connected the main power to 5v as the pwm power (5V from the DJI frame) and I connected the esc sgn to the aq board.
I connect a ubec 5V after the lipo and connected it to the frame to have 5v outpout. I connect the aq board to the frame to (so with 5v input). This is an example with only one esc32 but in fact I have 4 esc32 to connect and what I did was to connect all the esc main power to the frame, and connect all the esc pwm power together (4 reds together 4gnd together in a connector XT6 and connected that connector to the frame).
Tell me if I make a mistake doing that... I'm so sad, I have to buy other esc and there are not available in viacopter and in flyduino ... so I can't do anything right now. (there are other esc that I can use with autoquad without any problems)....
Thanks for reply and your help... I'm really sad