Re: ESC32 with T-Motor U8-Pro
Posted: Fri Sep 26, 2014 6:43 am
Hi Chris,
Your Motor is asking for 28A at 15.95V.
So you should set your max. to 29-30A.
I need to have a look at the current limiter results when I'm back home since my tablet will not open the file (for whatever reason).
Maybe you should start with a calibration current of 15A. You can try to increase it (if needed).
Boom diameter = Armdurchmessser = 18mm
Might be a little less; needs to be verified when the U8 is running properly.
this is a big prop --> you may need to increase start voltage and advance to make it start smoothly.
Joerg
Your Motor is asking for 28A at 15.95V.
So you should set your max. to 29-30A.
I need to have a look at the current limiter results when I'm back home since my tablet will not open the file (for whatever reason).
Maybe you should start with a calibration current of 15A. You can try to increase it (if needed).
Boom diameter = Armdurchmessser = 18mm
Might be a little less; needs to be verified when the U8 is running properly.
this is a big prop --> you may need to increase start voltage and advance to make it start smoothly.
Joerg