To have the best control with your Tx you need to have the RC values go from 0 to 1400 or from -700 to 700.
You can do this by adjusting the radio channels in your Tx. Look for a video on youtube for your Tx if you don't know how to limit the range of your Tx channels.
Larry
ESC32 with T-Motor U8-Pro
45 posts
• Page 5 of 5 • 1, 2, 3, 4, 5
Re: ESC32 with T-Motor U8-Pro
by TheBone » Sun Jun 28, 2015 4:30 pm
- TheBone
- Posts: 50
- Joined: Tue Apr 29, 2014 2:50 pm
Re: ESC32 with T-Motor U8-Pro
by LPR » Sun Jun 28, 2015 5:07 pm
- LPR
- Posts: 1323
- Joined: Tue Jun 26, 2012 1:29 pm
- Location: MN, USA
Re: ESC32 with T-Motor U8-Pro
by TheBone » Sun Jun 28, 2015 8:31 pm
Last edited by TheBone on Sun Jun 28, 2015 11:38 pm, edited 1 time in total.
- TheBone
- Posts: 50
- Joined: Tue Apr 29, 2014 2:50 pm
Re: ESC32 with T-Motor U8-Pro
by LPR » Sun Jun 28, 2015 9:56 pm
Chris
Does the AQ flight controller arm?
Larry
Does the AQ flight controller arm?
Larry
- LPR
- Posts: 1323
- Joined: Tue Jun 26, 2012 1:29 pm
- Location: MN, USA
Re: ESC32 with T-Motor U8-Pro
by TheBone » Sun Jun 28, 2015 11:38 pm
Yes, the M4 arms.
Okay, found the failure. In German we would say failure 40. ^^
I interrupted the CAN wire to the N4 board. After I replaced it I got wonderful results, also due to the new configured radio.
Okay, found the failure. In German we would say failure 40. ^^
I interrupted the CAN wire to the N4 board. After I replaced it I got wonderful results, also due to the new configured radio.
- TheBone
- Posts: 50
- Joined: Tue Apr 29, 2014 2:50 pm
45 posts
• Page 5 of 5 • 1, 2, 3, 4, 5
Who is online
Users browsing this forum: No registered users and 7 guests