Can't connect to ESC32 through qgroundcontrol_aq-Win32-1.3.0
Posted: Tue Apr 08, 2014 5:38 pmDear all,
After hours spent on trying to connect my ESC32 to QGC through the USB/FDTI adaptator, I have found out that the version Win32-1.3.0 of QGC cannot connect with the ESC32. I have tried with Windows XP Pro 32 bit and Windows 7 64 bit. However, it is still possible to use this version to flash the firmware, only if the six wires (RTS, RX, TX, 3.3V, CTS, GND) are plugged. One can flash, but not read the parameters. Moreover, after flashing, the software do not recognize the firmware version: "firmware version [Unknown]" is displayed.
It works fine with the version Win-v1.0.5 and Win32-1.2.1.
Hope this post may help some of you.
Cheers
Quentin
After hours spent on trying to connect my ESC32 to QGC through the USB/FDTI adaptator, I have found out that the version Win32-1.3.0 of QGC cannot connect with the ESC32. I have tried with Windows XP Pro 32 bit and Windows 7 64 bit. However, it is still possible to use this version to flash the firmware, only if the six wires (RTS, RX, TX, 3.3V, CTS, GND) are plugged. One can flash, but not read the parameters. Moreover, after flashing, the software do not recognize the firmware version: "firmware version [Unknown]" is displayed.
It works fine with the version Win-v1.0.5 and Win32-1.2.1.
Hope this post may help some of you.
Cheers
Quentin