Can't connect to ESC32 through qgroundcontrol_aq-Win32-1.3.0

Info and Discussion about the ESC32 hardware and software

Can't connect to ESC32 through qgroundcontrol_aq-Win32-1.3.0

Postby QuenS » Tue Apr 08, 2014 5:38 pm

Dear all,

After hours spent on trying to connect my ESC32 to QGC through the USB/FDTI adaptator, I have found out that the version Win32-1.3.0 of QGC cannot connect with the ESC32. I have tried with Windows XP Pro 32 bit and Windows 7 64 bit. However, it is still possible to use this version to flash the firmware, only if the six wires (RTS, RX, TX, 3.3V, CTS, GND) are plugged. One can flash, but not read the parameters. Moreover, after flashing, the software do not recognize the firmware version: "firmware version [Unknown]" is displayed.

It works fine with the version Win-v1.0.5 and Win32-1.2.1.

Hope this post may help some of you.

Cheers

Quentin
QuenS
 
Posts: 7
Joined: Wed Jan 15, 2014 6:11 pm

Re: Can't connect to ESC32 through qgroundcontrol_aq-Win32-1

Postby Trnquill » Tue Apr 08, 2014 5:45 pm

I have the same issue on my laptop (W7 64-bit) but not on my desktop (W7 64-bit). I cannot figure out what might be different between the two. OS is the same, FTDI-adapter is the same, QGC version is the same.
Trnquill
 
Posts: 158
Joined: Thu Jun 06, 2013 9:35 am


Return to ESC32

Who is online

Users browsing this forum: No registered users and 8 guests

cron