AutoQuad Forum

Hi, all.
An error happened in my ESC32.
Please check the attached photo.
I soldered "vb" in ESC32.
Then, I connected "signal (white cable)" and "minus (black cable)" to AQ6.
When I powered up for ESC32 and AQ6 through 3S 45C 5200mAh, the error LED in ESC32 shone.
How did I solve this problem? Any suggestion?
Thanks for help.

It is not necessarily an error.
If it was red flashing, all is good. When you arm the AQ it should go to green.


- red flashing no valid PWM signal (<750us or > 2100us) or prop strike or over current
- green ready / armed
- off running mode

Cheers

Christof

Hi, Christof,
Thanks for your reply.
Based on your suggestion, I will try to arm my AQ6.
Thanks again.