by Skripo » Mon Mar 10, 2014 7:42 pm
Steve,
I ran out and got the cable you recommended, and lo and behold, everything worked. I was able to upload the firmware 2.p R49 to all 5 ESCs, even the one I applied 5 volts to and probably shorted at some point.
By the way, did you solder a jumper or a switch onto the boot jumper? It would be a pain in the but to that while it is mounted in the model. I prefer a switch to avoid inadvertent shorts. What do you recommend?
The firmware uploaded and verified perfectly BUT QGC 1.3 cannot read the firmware version nor can it load the defaults or write. In fact it sometimes crashes.
What now?