ESC32 First inclusion

[ARXITEKTOR]

I received the ESC32 regulator.
There is a crossing point of 5 Volts.
I connect food of 5 Volts with UBEC via the receiver I I connect the Li 3S accumulator. The engine is connected.
On the regulator quickly we blink a red light-emitting diode.
To start work primary control via the personal computer is obligatory?

[kinderkram]

Welcome to the AQ club!

You have the ESC only connected to the receiver? Then trim down your throttle to make it arm.

Norbert

[ARXITEKTOR]

[kinderkram]

If by "Programator" the QGC GUI is meant, then yes: you only need to connect it to either flash new firmware or change the settings - which is recommended when you use certain motors, e.g. "MAX_CURRENT" which is 20A by default.
http://autoquad.org/wiki/wiki/esc32/esc ... and-modes/

[ARXITEKTOR]

Will be suitable for control.
such retrip
http://www.banggood.com/CP2102-6-Pin-US ... 15886.html
whether also it is possible to use it for an insertion?

[kinderkram]

Yes, you can use a USB/serial module like this for programming the ESC32s.

[ARXITEKTOR]

I received an adapter.
For control and change of parameters I have to connect contacts of an adapter of USB-UART to the corresponding contacts of the regulator?
GND-GND RXC-RXC TXC-TXC 5V-5V
contacts 3.3 and RST shouldn't be connected?

[bluuu]

TX-RX
RX-TX
GND-GND
+5V - +5V
RST and 3,3 leave alone

[ARXITEKTOR]

I can't connect to APM the flight controler constantly blinks the red.
What settings I have to make and what version of an insertion to use?

[kinderkram]

The AQ is prepared to work best with the ESC32s. It outputs 5V on the middle pin of the PWM connector.
If you use other FCs you need to either provide 5V for the ESCs through a UBEC or solder the bridge on the ESC so it uses the main flight battery.

http://autoquad.org/wiki/wiki/esc32/esc ... e-flashing