just finished the ESC32 calibration procedure for the combination below:
T-Motor MN3510-10 630KV (http://flyduino.net/Multikopter-Brushle ... avigator_3)
and
RCTimer (?) 13x5.5in CFK prop for Navigator series (http://flyduino.net/1355T-Carbon-Fiber- ... ator-Motor).
Here are the calibration results. Would be fine if somebody could check them and report back (since I think there's room for improvements).
I've used a 4S1P 6000mAh 25-50C lipo (http://www.hobbyking.com/hobbyking/stor ... ouse_.html) with the overall current limit set to 25A and the calibration current limit set to 18A.
I think I will have to further increase the current limit to allow the motor to reach 100% duty (because of the results below):
..
Duty 80 to 90, MAX current = 25.145353
Duty 85 to 90, MAX current = 0.005814
Duty 85 to 95, MAX current = 0.005686
Duty 85 to 100, MAX current = 0.004575
Duty 90 to 95, MAX current = 0.002401
Duty 90 to 100, MAX current = 0.001435
Nevertheless, here are the (preliminary) results:
- ESC32_MN3510-15_630kV_1355T CFK.zip
- (1.97 KiB) Downloaded 774 times
Kind regards
Joerg
aBUGSworstnightmare