FF1TERM and FF2TERM zero after calibration?

[chschmid]

What kind of motor is that? Do you have timing and switching frequency right? Can you provide some info about the motor and post a screenshot of qgc with your params.

Cheers
Christof

[proff]

sorry I just have the shop mall description on altigator web site
that's all what I can say about this motor that I took in an old drawer in my job office ...(I'm still under new user restrictions I can not post url at this time)

[chschmid]

So you have to post more.

Cheers
Christof

[proff]

you're right christof ! but I dont whant to be tagged as spammer too !
anyway jokes aparts, herse my config for these motor

as soon as I can I will post url fo motor des on altigator web shop (but it's not so detailed)

i finaly suceeded in calibrating
i chang few thing on start accelleration and with a 14 amps limit it looks to work and rpm values looks good
thank's for your help

[chschmid]

Startup mode should be 0 (open loop) for normal operation.
Your advance seems to be low for a high pole Motor.
Max current should be set to 14A or 15A if you used 14A that for calibration.

Cheers
Christof

[bluuu]

Could you write type of this motors ?