Hello, first time here..
I just got my ESC32 up and running. I successfully flashed a couple different versions of the firmware onto the unit, r32 and r42 using a flyduino usb-uart, QGC and Windows 7.
Out of the box and after flashing, I get blinking a red light. When I attempt to connect using the QCG to configure settings, it will not arm, load or read any settings.
I had to short the boot jumper the entire time in order to flash. Is there anything else I'm doing incorrectly that would prevent it from connecting?
I am interested in uploading a firmware that allows me to use 'Servo Mode' Does anyone have any information about servo mode? In QGC it says (v1.5+) Which revisions of firmware would that be?
Thanks,
Dave