Any help is welcome to recover this ESC32.
Thanks
Angel
ESC32 boot contact broken: help!
5 posts
• Page 1 of 1
ESC32 boot contact broken: help!
by afernan » Sat Oct 19, 2013 10:51 am
- Attachments
-
- New Picture.jpg (172.65 KiB) Viewed 6989 times
- afernan
- Posts: 1214
- Joined: Sat Jul 07, 2012 5:24 pm
- Location: Madrid, Spain
Re: ESC32 boot contact broken: help!
by JussiH » Sat Oct 19, 2013 11:05 am
You can short the R8 pad that is closest to U1 to ground and it will go into flash mode. With recent versions of the ESC32 FW you dont need to short the jumper to enter flash mode, It can be done by sending a serial command via from CLI.
- JussiH
- Posts: 2103
- Joined: Thu Jun 21, 2012 9:25 pm
Re: ESC32 boot contact broken: help!
by afernan » Sat Oct 19, 2013 7:55 pm
@Jussi, Thanks!
I´ll try that
Angel
I´ll try that
Angel
- afernan
- Posts: 1214
- Joined: Sat Jul 07, 2012 5:24 pm
- Location: Madrid, Spain
Re: ESC32 boot contact broken: help!
by Max » Sat Oct 19, 2013 9:23 pm
Try flashing the ESC fw with QGC1.3. If it works, then you don't need the jumper. 
-Max
-Max
- Max
- Posts: 2814
- Joined: Mon Aug 13, 2012 9:45 pm
- Location: Near Ithaca, NY, USA
Re: ESC32 boot contact broken: help!
by afernan » Fri Nov 08, 2013 6:04 pm
Worked!
used r42
thanks for this nice improvement
Angel
used r42
thanks for this nice improvement
Angel
- afernan
- Posts: 1214
- Joined: Sat Jul 07, 2012 5:24 pm
- Location: Madrid, Spain
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 22 guests