I accidentialy did the Cl and R2V calibration with the wrong poles number.
Does this effect the calibration data in some kind, do i have to repeat the whole prozess?
CL & R2V calibration with wrong pole number
2 posts
• Page 1 of 1
CL & R2V calibration with wrong pole number
by teramax » Tue Jul 30, 2013 11:10 am
Hello
I accidentialy did the Cl and R2V calibration with the wrong poles number.
Does this effect the calibration data in some kind, do i have to repeat the whole prozess?
I accidentialy did the Cl and R2V calibration with the wrong poles number.
Does this effect the calibration data in some kind, do i have to repeat the whole prozess?
somehow everything can fly
- teramax
- Posts: 500
- Joined: Sun Sep 02, 2012 11:19 pm
- Location: Lower Austria
Re: CL & R2V calibration with wrong pole number
by bn999 » Tue Jul 30, 2013 3:47 pm
It will make the RPM calculations come up with the wrong value. It would be fine if all of the ESC32's you placed the parameters on were set to the same wrong pole count, unless you intend to use any of the closed loop modes.
- bn999
- Posts: 1559
- Joined: Thu Jun 21, 2012 11:40 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 21 guests