Hello,
I am trying to connect ESC32 board to computer (windows 7). However, the ESC32 cannot be armed (red light keeps flashing) even after I pressed connect and arm button . I am using FTDI basic adapter ( FTDI Basic 5V - I cannot post a complete link because I am a new member ). I did not connect PWM signal, battery, capacitor to the board. All I did is to set the jumpter for power source selection to V5 and connect the FTDI basic adapter to FTDI port. I believe that the power from FTDI port will be used to power the ESC32 board. I just bought the board from Flyduino but I don't know what is the version of the firmware. I have tried to
1. Use qGroundControl ver 1.05 and 1.21.
2. Set the baud rate of the FTDI basic adapter to 230400 (Data bit 8, parity none, stop bits 1, flow control none).
3. Add a communication link in qGround Control.
Still the ESC32 board will not be armed.
Is the FTDI basic adapter compatible with the board?
Am I doing something wrong?
Any suggestion would be very greateful