ESC32 Mode Selection (thrust mode cannot be saved)

[monkey1]

I have updated ESC32 Mode to Thurst, it's no problem to write it and reload the config. However, after closed the QGC and reopen the QGC to read the ESC32, the ESC32 mode will change to RPM. I have attached my ESC32 Settings, anybody have idea to correct it?

Thank you.
monkey1

[sandmen]

Hi,
at the moment you can not switch to different mode's from the qgc.
It's not available in the esc32 fw.

[LPR]

Monkey

Here's some more info on thrust mode if you are up to monkeying around with it.

viewtopic.php?f=26&t=1731&p=7108&hilit=thrust#p7108

Larry

[monkey1]

i have read it before, and seup ubuntu already. i use linux to get the values, it can seen the rpm and amp values which seem to be accurate than qgc.

If i use Linux/Putty set "startup_mode 2", after then i return to qgc, will the mode changed back to rpm?

[Kisssys]

[monkey1]

Thank you kisssys.