No way to change the values using "esc32.txt" file method from here:
http://autoquad.org/wiki/wiki/esc32/esc ... -autoquad/I´m in AQ (r220) and ESC32 (r42). I´ve tryed all ú can imaging. ESC32 seems to receive the file (small beep after reset AQ), but parameters don´t load into it. This is what I do.
1.- Create the "esc32.txt". Save into the uSD root
2.- Start AQ and ESC32.
3.- Introduce the uSD and reset the AQ. A beep is done by ESC32
I´m using the params in file attached (taken from the QGC saving params), but also i´ve tryed to writte by hand.
What I´m doing bad?
thanks
Angel