Can anyone point out which gpio pin is vacant to toggle?
I would like to use it for debugging (measuring computation time) with oscilloscope
Empty GPIO pin to toggle?
4 posts
• Page 1 of 1
Empty GPIO pin to toggle?
by hyonlim » Mon May 06, 2013 9:28 am
- hyonlim
- Posts: 15
- Joined: Wed Apr 17, 2013 12:56 pm
Re: Empty GPIO pin to toggle?
by bn999 » Mon May 06, 2013 3:43 pm
On the expansion connector J2 pin 11 you can access the MCU's PD10 which is safe to use.
- bn999
- Posts: 1559
- Joined: Thu Jun 21, 2012 11:40 pm
Re: Empty GPIO pin to toggle?
by hyonlim » Mon May 06, 2013 3:57 pm
Which one is expansion connector J2 on ESC board?
Because there is no schematic provided, hard to tell which one is J2.
Because there is no schematic provided, hard to tell which one is J2.
- hyonlim
- Posts: 15
- Joined: Wed Apr 17, 2013 12:56 pm
Re: Empty GPIO pin to toggle?
by bn999 » Mon May 06, 2013 5:30 pm
- bn999
- Posts: 1559
- Joined: Thu Jun 21, 2012 11:40 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests