Gents
Today I was setting up the new Motors and Props.
AQ FW 100 Build 1068
ESC32 FW 1.4.1
Tiger Motor MN 3508 700
Tiger Prop 12x45
Lipo 4s
QGC 1.0.5
ADVANCE 15°
Other standard
After doing some calibration runs, 16Amps @ 4S was the max that produced values. All amps above came up with "NAN".
Writing these values to ROM, Setting Current Limiter to 20Amps and testing the Set RPM went well. @ full RPM I measured ca 16Amps.
Then I connected the ESC32 to my Testtool UniTest. @PWM1100 the Motor starts, was ramping up nicely but @ PWM 1700 and 13Amps it cut off. In one run it stalled around 1650.
How can I test the ESC32 and calibration for proper operation.
Thanks for all hints.
Christof