Olimex ARM-USB-TINY-H to SWD?

[hyonlim]

I just obtained ARM-USB-TINY-H.
But, the SWD connection is not working properly.

Have anyone connected ARM-USB-TINY-H to ESC32 board using CrossStudio 2.x?

The ESC32 is rebooted when I double click the targets, but "read failed" message shown.

I've changed setting to

Target interface type : SWD
Adaptive clocking : Yes (If I choose NO, no reset signal working)
JTAG Clock divider : 1 (I've tried 10 to 64, but not working)

[Kisssys]

I had good luck with the Olimex-arm with the full JTAG but when I tried the swd adapter I never got it to work. ST-Link works fine and the discovery board has a St-link onboard which works fine also.

[hyonlim]

What did you mean?
Which JTAG is working with ESC32?
The ESC32 only has SWD connector.

[Kisssys]

The AQ5 had a 20pin JTAG. Yes the ESC32 only has a SWD 10pin .05" connector. And what you asked about I never got to work in CrossStudio, others may have. I think Srinath had one but not sure if he got it to work.

[hyonlim]

Do you think this problem is because of hardware or software?

[Kisssys]

I would contact Olimex, they claim capatibility.