Hi,
i was just doing esc32 calibration for current limiter with GroundControl 1.1.0A3 and got following problem:
I start calibration with 8 amps. I use Robbe Roxxy BL 2824-34 motors, max. current 9A (for 60 sec.).
Everything worked fine and i got 5 current limiter values.
(I made screenshots but cant upload them because its my first post).
So these are the values after calibration, but before writing to esc memory:
CL1 0.481829
CL2 0.000875531
CL3 -0.100584
CL4 -9.98912e-06
CL5 1.67849
When im writing the values to rom and load them again i got the following values:
CL1 0
CL2 0
CL3 +4.81829e-01
CL4 +8.75531e-04
CL5 -1.00584e-01
It seems, the values got mixed up.
CL1 and CL2 is set to zero.
CL3 has got exactly the value from CL1 after calibration
CL4 has got exactly the value from CL2 after calibration
CL5 has got exactly the value from CL3 after calibration
I tried different FW on esc32 (1.4, 1.4.1) - everytime the same.
After many hours of trial and error I tried GroundControl V1.0.5 and everything works fine.
(After reading from esc i got the same values for CL1-5).
So I guess, it has something to do with V1.1.0A3 of GroundControl software?
Is this a bug or did I do something wrong?
btw, i was using GroundControl for Win7.
Chris