by xanion » Tue Feb 04, 2014 1:00 am
Hi there,
I cannot arm my FC, and I don't know why.
I'm using Hacker Brushless Controller "X-40 OPTO PRO".
Radio communication works fine as I can see in the telemetry. I see throttle at 0 to -1 and yaw at approx. 705, but the FC is not arming.
Even though when I plug the battery all motors give a sound that they are initialized.
When I connect whatever Brushless Controller to the Ch1 of the radio receiver, the corresponding motor spins on setting some throttle.
I didn't find any information of my Brushless Controller for PWM frequencies / periods etc. And I didn't find where I can set the values in the QGC (v1.3.0), that are mentioned in the posts before. FC firmware is 6.7 r224.
Ready LED is blinking (1 Hz)
Power LED is continuously turned on
Debug LED is blinking fast
GPS LED is blinking (inside the apartment!!!)
So, how can I get rid of that problem(s)?