wiki on ESC32 shows 3 blue wires connect to the motor
How do I connect a motor with RED Black and YELLOW colored wires ?Kit contents:
ESC32, SMT-preassembled and factory tested board.
25 cm servo wire with open end.
Input power wires
330uF/35V lowESR capacitor
1*6 pin header for UART
I did not get any 6 pin headers with any of my 6 ESC32 just like I did not get a 6 pin header with AQ6
I did get a very wide piece of heatshrink
What is the wide heatshrink for ?Is the ESC32 already flashed or do I need to flash it before use ?