ESC32 Q&A

[DUKE40]

Hi,

a new question, or more seeking a confirmation.
In the GUI in the Tab "ESC32 Settings" in the part "General" there is a selctbox direction with the two option forward or Reverse.
Does this mean I can change the direction the motor is running just by changing this parameters without needing to switcj the cables between motor an ESC32?
Would be great if someone could confirm this.

Thanks and best regards,

[aBUGSworstnightmare]

[DUKE40]

Hi,

in QGC for the mixing table of the AQ for the Port/ID it starts at 1 up to 16
For the ESC32 settings the CANID goes from 0 to 16.
Does this mean that an ESC32 with CANID 0 will never get any signal?
Or does this mean ID 1 in mixing table is CAN0 in ESC32 settings?

Just to be sure I configure my ESC and AQ correctly.

[plexus]

Read that and you will understand, may be:
viewtopic.php?f=42&t=3203&p=21118#p21119

Alain

[Crizz]

guess CAN is only for people with binary brain in the first, "normal" humans not able to understand.

(There are 10 different kind of beings : those who can think binary and those who can´t )

[chschmid]

It is much easier. On the ESC32 side, CANID 0 is default and means, no CAN used.
If you want to use CAN, every ESC needs a unique valid ID (1-16) that refers to the Motor mixing table.
What Plexus mentioned in Mennos Post is MOT_CAN_L. But that param is calculated for you by QGC. But it is still good to understand what this param is for and how it is calculated.


Cheers
Christof

[strips]

Will ESC32 v3 support 6S?

[aBUGSworstnightmare]

Yes! V3 will support 6S, but ist's not released yet.

[strips]

[DUKE40]

Hi,

I would like to see the graphs of my current limiter calibration.
Importing the file in any spreadsheet program is not an issue, but creating the graph is unclear for me.
Which values should be taken?
Worst is the TXT file resulting from the RPMtoVoltage calibration.

Any help would be great.