Page 1 of 1

ESC32V3 mount on Warthox centerplate

PostPosted: Tue Aug 30, 2016 7:06 pm
by afernan
I´m building a small quad with ESC32V3 and the well known Warthox centerplate (http://flyduino.net/Quadrocopter-Center ... n-set-of-2)

I want to show the installation solution I did that keeps a clean mount together with a protected ESC´s and easy access to USB connector from external side.
Attached the file for the small 3DPrinted part used . Used ABS; weights 2g each. M2.5 Bolts screwed directly into 2mm holes in part.
Note the small velcro ("loop" type) below the ESC´s to protect & isolate their botom side against frame surface.
Hope you like
Angel

Re: ESC32V3 mount on Warthox centerplate

PostPosted: Wed Aug 31, 2016 4:14 am
by chschmid
Hi Angel

Very nice design as always.
Please keep in mind to mecanically fix the cap. One of my first hexas lost 3 caps due to vibrations. The wires broke and the hex came down. The escs where below the motors though.

Cheers
Christof

Re: ESC32V3 mount on Warthox centerplate

PostPosted: Wed Aug 31, 2016 5:45 pm
by afernan
Hi Christoff:
Thanks for the comment. Yest I thought on that; I plan to setup a drop of hot glue to fix to the board.
Angel