ESC32V3 mount on Warthox centerplate

Show us your flight videos and pictures of your aircrafts

ESC32V3 mount on Warthox centerplate

Postby afernan » Tue Aug 30, 2016 7:06 pm

I´m building a small quad with ESC32V3 and the well known Warthox centerplate (http://flyduino.net/Quadrocopter-Center ... n-set-of-2)

I want to show the installation solution I did that keeps a clean mount together with a protected ESC´s and easy access to USB connector from external side.
Attached the file for the small 3DPrinted part used . Used ABS; weights 2g each. M2.5 Bolts screwed directly into 2mm holes in part.
Note the small velcro ("loop" type) below the ESC´s to protect & isolate their botom side against frame surface.
Hope you like
Angel
Attachments
1.JPG
IMG_20160830_195602.jpg
soporte esc32v3 Q6.zip
(10.96 KiB) Downloaded 48 times
IMG_20160830_195527.jpg
IMG_20160830_195538.jpg
afernan
 
Posts: 1214
Joined: Sat Jul 07, 2012 5:24 pm
Location: Madrid, Spain

Re: ESC32V3 mount on Warthox centerplate

Postby chschmid » Wed Aug 31, 2016 4:14 am

Hi Angel

Very nice design as always.
Please keep in mind to mecanically fix the cap. One of my first hexas lost 3 caps due to vibrations. The wires broke and the hex came down. The escs where below the motors though.

Cheers
Christof
chschmid
 
Posts: 1800
Joined: Wed Jul 11, 2012 7:41 pm
Location: Herrliberg, Switzerland

Re: ESC32V3 mount on Warthox centerplate

Postby afernan » Wed Aug 31, 2016 5:45 pm

Hi Christoff:
Thanks for the comment. Yest I thought on that; I plan to setup a drop of hot glue to fix to the board.
Angel
afernan
 
Posts: 1214
Joined: Sat Jul 07, 2012 5:24 pm
Location: Madrid, Spain


Return to AQ Media Showcase

Who is online

Users browsing this forum: No registered users and 2 guests