Page 2 of 2
Re: New Quad project based on reference quad
Posted:
Tue Feb 17, 2015 7:29 am
by teramax
Leopold, good to hear that.
I dont know how far out in the arms your KISS are, i mounted them on a second build direct under the motors and had to ad a capacitor and a shieldet signalwire to each of them to work propper without any glitches.
Re: New Quad project based on reference quad
Posted:
Mon Apr 27, 2015 6:52 am
by leopold1
After some uncontrolable vibes and suggestions from Afernan I'm doing a major upgrade on this build. Four ESC32 are going to be installed.
Concerning hookup of the ESC's, do I need to power the esc's seperatly so that I can power logic and AQ before I power motors? Or is it ok that everything is powered at the same time when I connect the battery?
Re: New Quad project based on reference quad
Posted:
Mon Apr 27, 2015 2:54 pm
by teramax
its OK when alls components are powered the same time.
Re: New Quad project based on reference quad
Posted:
Sun May 24, 2015 4:40 pm
by leopold1
I skipped the ESC32 and turned bck to KISS and changed the frame.
The full story is here:
Meanwhile this is my firts test with DYS 3 axis gimbal and gopro3.
It was windy but video is quite ok.
Re: New Quad project based on reference quad
Posted:
Sun May 24, 2015 5:47 pm
by teramax
very nice Leopold
hearing the motor sound i would mention to lower TRD a little, just to give it a try
Re: New Quad project based on reference quad
Posted:
Sun May 24, 2015 8:02 pm
by leopold1
Thanks, will do.
Is now at 12000.
Re: New Quad project based on reference quad
Posted:
Sun May 24, 2015 9:40 pm
by leopold1
At what certain times do you heat the problemen? Maybe it is because I switched to PH a couple of times.
Re: New Quad project based on reference quad
Posted:
Sun May 24, 2015 10:12 pm
by teramax
i heared it the most time in the video, aim for somethig around 6-8000 and give it a try, should run smoother than.