@Joerg:
Thanks. Most is clear. A few clarifications:
-The note "JP1 CLOSED, VCOM max +4.5v!". Do I need to close JP1 or not, to waranty +4.5v in +VB?
- the BLDC board is powered by who?: by the +5V in one of the ESC´s or by the pins marked as "power"?. If "power" is used (I guess batery connected to it) do I need the +5V?
- For voltage sensing I´ll close JP2 and configure PA6 as ADC12_IN6. Where in the code?
Thanks for your help
Angel
KISS on AQ board
14 posts
• Page 2 of 2 • 1, 2
Re: KISS on AQ board
by afernan » Fri Oct 17, 2014 8:45 am
- afernan
- Posts: 1214
- Joined: Sat Jul 07, 2012 5:24 pm
- Location: Madrid, Spain
Re: KISS on AQ board
by aBUGSworstnightmare » Sat Oct 18, 2014 8:25 am
- Attachments
-
m4_r5_r432_modforBLDCuse.zip- (156.6 KiB) Downloaded 759 times
-
- supply.png (37.46 KiB) Viewed 7584 times
-
- 0805 SMD LED
- powerled.png (533.67 KiB) Viewed 7584 times
-
- +5V supplied by ESC/BEC to the pin with the white circle
- ESC connection.png (640.99 KiB) Viewed 7584 times
- aBUGSworstnightmare
- Posts: 1460
- Joined: Fri Jun 22, 2012 5:24 pm
Re: KISS on AQ board
by edge0xc » Thu Oct 30, 2014 2:35 pm
@aBUGSworstnightmare
i cant PM you jet, but do you have this breakout for salè? i hope to buy a m4 tonoight and want to try it with PWM escs first.
Cheers,
Alex
i cant PM you jet, but do you have this breakout for salè? i hope to buy a m4 tonoight and want to try it with PWM escs first.
Cheers,
Alex
- edge0xc
- Posts: 7
- Joined: Tue Oct 21, 2014 6:35 pm
14 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 6 guests