AutoQuad Forum

After my terrible crash, most possibly caused by a lost caps due to vibs I was learning some 3D drawing in the last days and built a housing for ESC32 and caps. Hopefully this will prevent the caps from falling off.
The first fairly good PLA print was ready this morning. I am still experimenting a little with the printer settings.

Cheers
Christof

ESC32 Halter.jpg (27.36 KiB) Viewed 24903 times

ESC32 Halter 1.jpg (30.03 KiB) Viewed 24903 times

This is realy awesome

Do you think gluing only is enough? Hm, i would ad some supporttube or inlet in the arm.
Maybe somthing 3D printed.

Chris all thumbs up for your projekt!

yes exactly, just to prevent not to sqeece the arms to much.
Nice build as always.

I am working on the power distribution.

Whats the better solution regarding magnetic fields and EMI:

1. a closed ring wire with connections
2. an open ring wire with Connections

Power Disribution.png (29.02 KiB) Viewed 24785 times

Thanks for your comments

Cheers
Christof

BTW
I am making some progres

Ok, no answers. So I will try it out.
The distribution is ready. It is completly 3D drawn and can be replicated any time.

copper ring 4mm2

housing with copper ring

insulation added

two (+ and -) added to one ring

The motormounts are ready too. This is the 3D printed proof of concept.

Motormount ready

dampened ESC32 Mount

cheers

Christof

maybe theres no answer cause no one realy knows
So it´s on you to proof!

Ahm btw. perfekt as always Respekt