by chschmid » Mon Jun 23, 2014 9:27 pm
Finally the machine is up and flying well.
Todays flight:
Mavlink init
ADC init
ADC task started
DIMU: EEprom init
DIMU: Reading values from EEprom
DIMU: read calibration parameters from EEPROM
Battery cells: 4
Radio init
GPS init
Nav init
Command interface init
CAN: Found 8 node type ESC
Motors init
Radio task started
GPS task task started
ESC32: CAN ID: 1, ver: 2.1.0
ESC32: CAN ID: 2, ver: 2.1.0
ESC32: CAN ID: 3, ver: 2.1.0
ESC32: CAN ID: 4, ver: 2.1.0
ESC32: CAN ID: 5, ver: 2.1.0
ESC32: CAN ID: 6, ver: 2.1.0
ESC32: CAN ID: 7, ver: 2.1.0
ESC32: CAN ID: 8, ver: 2.1.0
Control init
Quatos init
Quatos license passed
Control task started
Gimbal init
Gimbal combined PITCH & TILT port initialized.
Gimbal ROLL stabilization port initialized.
Gimbal TRIGGER control port initialized.
Gimbal radio PASSTHROUGH port initialized.
HoTT Telemetry init
HoTT enable ESC32 monitor
AQ S/N: 36373532-3331470B-00360034
Mavlink SYS ID: 246
SYS Clock: 168 MHz
8639/9008 heap used/high water
33232 of 40960 CCM heap used
Run task started
AQ FW ver: 7.0 - EXPR rev403 b1762, HW ver: 6 rev1
Disarmed
HoTT Telemetry task started
Initialization complete, READY.
GPS: trying new baud rate
Waypoint recorded
AQ FW ver: 7.0 - EXPR rev403 b1762, HW ver: 6 rev1
RTC set: 2014-06-23 18:18:48 UTC
Armed
Altitude Hold engaged
Home position set
Position Hold engaged
Returning to home position
Home position set
Returning to home position
Returning to home position
Returning to home position
Returning to home position
Returning to home position
Returning to home position
Disarmed
Set new reference heading for Heading-Free mode
Armed
Altitude Hold engaged
Position Hold engaged
Now in locked Heading-Free DVH mode
Now in normal DVH mode
Disarmed
config: Parameters saved to flash memory.
Armed
Altitude Hold engaged
Position Hold engaged
Disarmed
Waypoint recorded
Thanks for everybodys support.
Cheers
Christof
Last edited by
chschmid on Tue Jun 24, 2014 4:44 am, edited 2 times in total.