reference Hexacopter + FCP-HL medium lift

[afernan]

This is the result of my end fittings for landing leg from shapeways.
Very nice manufacturing. Material (black nylon) is very strength and light.

Angel

[teramax]

yes, thats nice!
Did you make it for the new 1,5mm thick booms or the old 1mm ones?
And please ad also the outer rings.

Thanks

[Astudillo]

afernan that's looking really nice! And good to hear the strength of the 3d printed parts is sufficient

[Jdmagoo]

Max,

What start voltage are you using on your esc32? I have the same motors and have tried a start voltage of 1.1 then 1.7 but find occasionally one or more motors will not start until I disarm and re-arm. Sometimes they will start but don't run at the same rpm as the others until I re- arm again. I'm running your esc32 settings that you posted a few pages back as I'm also using the t- motors 11x4.5 cf props as well.

Cheers

James

[teramax]

mine is at 1,1 but sometimes when the copter does not stand perfekt level there are also some motors not starting.
Still working on this.

settings in QCG.JPG (81.52 KiB) Viewed 11466 times

[bn999]

[Jdmagoo]

[teramax]

[Jdmagoo]

[teramax]